Some notices for drilling mud agitator buyers

The mud agitators are high-efficiency mud-mixing units which used for stiring mud slurry to maintain suspension of solids .The agitator is mounted on top of the mud tank and has one or two impeller immersed in the mud slurry. Mud mixing tank is working to keep drilling mud balance by add some chemicals. While drilling mud stay in tank , it will need mud agitators to avoid sedimentation.
Mud agitators utility notes for buyers:
1, check whether the mud agitator selection is correct, the actual conditions of use are consistent with the specified conditions of use.
2, the stirrer motor and two hard steel cable protection metal hoses in the mud tanks, to ensure sealing pipe connections.
3, with 0-500V Megger, check the motor three main cable wire insulation resistance of not less than 5 megohms, disabled Megger check control cables, submersible mixer avoid damage to the internal electrical components, and applications multimeter check control cable.
4, if the power supply using the distance from the mud agitator far, considering the line loss, cross-sectional area cable should be increased, the joints should be as little as possible and fittings for sealed to prevent leakage.
5, mud agitator power cable on the ground and control cables should control cabinet (box) wiring head butt one.
6, mud agitator grounding line color line (yellow / green), in order to ensure safety, must be connected securely, and grow than other lines 50mm.
7, stirrer control a fine thick cable of mud agitators, measured with a multimeter off, three of them with two fine pass for temperature measurement signal line, a color line and the signal line does not make sense for the leak.
8, mud agitator before final installation, facing the direction of the impeller, the impeller rotates counterclockwise. If the rotation direction is incorrect exchange position on the control cabinet or terminal box in any of the three-phase line two lines, you can change the direction of rotation. If several mud agitator mixers connect to a control cabinet or terminal box on the mud agitator mixer each station must be checked individually.
9, after the closing, the mud agitator cannot start immediately, should be through mud mixer control system self-test, if there is a fault (flashing alarm or alert warning appears on the cabinet), you should check and troubleshooting, and then only start If the motor does not turn, should quickly and decisively to wind up, you should check the troubleshooting, to avoid damage to the motor.
10, the stirrer of mud agitator started, should observe the motor and circuit voltmeter and ammeter, if abnormal, should immediately stop identifying the reasons for closing the troubleshooting before being re- start.
11, a few mud agitator cannot start together, you should start one by one.
KOSUN can manufacture types of drilling fluid solids control systems according to the requirements of different drilling conditions. KOSUN is well-know as a professional manufacturer and supplier of oil drilling solids control equipment in China. After 20 years development,KOSUN is becoming more and more stronger,can provide more efficient equipments at the same time, the products including drilling shale shaker, shale shaker screen, desander, desilter, vacuum degasser, centrifugal pump, submersible slurry pump, shear pump,mud agitator, mud gun, drilling fluid cleaner,drilling decanter centrifuge, jet mud mixer, mud tank, diesel tank, water tank, complete solids control system,etc.


http://www.china-kosun.com/kosun-solids-control-equipment/shear-pump.html